If the fluid is full then continue onto brake fluid is full down further in this guide.
Chevy astro van brake pedal to the floor.
A low brake pedal can also be due to a fluid leak or worn brake linings.
Repeat the previous steps for the remaining wheels.
Anytime you have a brake pedal that goes to the floor raise the hood and locate the brake master cylinder s reservoir.
They put answered by a verified chevy mechanic.
The chevy astro van may be equipped with both brake pads and shoes on its rear brakes.
Whether you are changing the pads or shoes you need to change them for both of the rear wheels together.
When stopped the brake pedal goes to the floor and the brakes let go.
While traveling at low speed cities parking lots etc.
When applying the brakes the brake pedal goes to the floor almost resulting in a collision.
The pads work with the brake pedal while the shoes primarily work with the parking brake.
My friend has a 93 astro van with awd.
While the pedal is depressed to its full extent tighten the bleed screw.
I took van to the mechanic 600 00 for new master cylinder and more do not have the list yet left the shop drive in van and abs brake went bonkers for a moment going five mph no problems with road etc seemed like right front.
Bleed the brake lines as recommended by chevy to fix this.
Slowly depress the brake pedal.
2000 chevy astro van abs problem.
Double checked the vacuum lines thinking it might be the booster however the booster would make the brakes harder to push not softer and there weren t any issues with the lines.
Brake pedal went to the floor seemed i would have no brakes.
Attempts checks so far.
Check the brake fluid level.
Release the brake pedal and wait 10 15 seconds for the master cylinder pistons to return to the home position.
Using a flashlight check the level of the fluid or just remove the lid of the reservoir and look inside.
The procedure can vary depending on the year of the van and if.
Brakes on a 97 chev astro have intermittent problem.
When i press pedal it doesn t go to floor at all it just presses hard and won t press any harder until i pump pedal a couple times and then the work like they should the van keeps rolling and i have to pump pedal.
Soft or spongy brake pedal.
Took vehicle to dealer and dealer was not able to solve the problem.
Too much air in the system due to improper bleeding is usually the cause of this problem.
However it can also be due to fluid loss or a low fluid level.
The brake fluid which is present at each bleed screw should be clean and free.
